CTSCH00C - Chrysler Dodge Jeep Amplifier Turn On Interface & Steering Wheel Control

The Steering Wheel Interface allows you to change the factory original headunit to an aftermarket car stereo whilst maintaining the use of your factory stalk/steering controls whilst retaining the use of the factory fitted amplifer.

Compatible with:

Vehicle with Grey Connector Head unit only

• Chrysler 200C (2011 - 2015)
• Chrysler 300C  (2006 - 2011)
• Chrysler Aspen (2008 - 2009)
• Chrslyer Pacifica  (2006 - 2008)
• Chrysler PT Cruiser  (2006 Onwards)
• Chrysler Sebring  (2006 - 2010)
• Chrysler Town & Country  (2006 - 2015)

• Dodge Avenger  (2007 - 2015)
• Dodge Caliber  (2006 - 2015)
• Dodge Caravan  (2008 - 2014)
• Dodge Charger  (2008 - 2010)
• Dodge Dakota  (2006 - 2011)
• Dodge Durango  (2006 - 2009)
• Dodge Journey  (2009 - 2010)
• Dodge Magnum  (2008 - 2015)
• Dodge Nitro  (2007 - 2011)
• Dodge Ram  (2006 - 2015)
• Dodge Stratus  (2006)
• Dodge Viper  (2006 - 2009)

• Jeep Commander  (2008 - 2010)
• Jeep Compass  (2009 - 2015)
• Jeep Grand Cherokee  (2006 - 2010)
• Jeep Liberty  (2006 - 2015)
• Jeep Patriot  (2009 - 2015)
• Jeep Wrangler  (2006 - 2015)

• VW Routan  (2009 - 2015)

• Mitsubishi Raider  (2008 - 2009)

The Steering Wheel Interface comes supplied wth a car stereo patch lead for use with

• Alpine
• Clarion
• Kenwood
• Pioneer
• Sony

This Can Bus interface gives the following outputs:

• Turn on the factory car amplifier
• Retain the use of the steering wheel interface
• Speed Signal Output for use with car navigation
• 500ma Ignition power source
• Sidelights output
• Handbrake output
• Reverse Gear output

Note: 

We make every effort to make sure that the information provided is correct.  If you are not sure on the suitability of the product, remove the original headunit and compare the original connector in the vehice to the photo to make sure it is the same.......

If you are still note sure, then simply contact our customer services.